Cusco adjustable top mounts on Konis problem

[speed-inc]

Hi guys

I know this was mentioned before but was not able to find the thread.

I just wanted to fit some Cusco top mounts onto my Koni dampers but the top screw is too big.

What was the solution to this??

Thanks for your help.

[gon]

had that problem......
just find normal nut's (not long ones) but with the locking bit or use loctite



with the T3 camber plates, i used smaller nuts on that picture.

but some time after i machined the camber plates a bit so that the locking bit actually touches the thread.

[speed-inc]

Did you just machine the existing nuts down?

Isn't it having some kind of play this way?

[The Doctor]

i did the same, without the bit going inside the camberplate, never had any problems with play at all

[gon]

it's not the camber plate that was machined (or the nut) it's a spacer that the T3 camber plates have between the shock absorber and the camber plate.
never had any problems with play with both solutions

[AshCampbell]

@speed inc

In verbindung mit den konis brauchst eigene muttern, ich schau dir zuhause mal nach, vielleicht habe ich noch die teilenummern bzw. die abmessungen von Tein.

[AshCampbell]

M12x1,25

[speed-inc]

Vielen Dank Ash

I see if Cusco has something matching.