4age 20valve in ae86

[sideways_madness]

hi can any1 on ere tell me what all i need to put a
20valve engine into my ae86??? an what kinna
money it will cost me?? not counting engine! thanks people!!

[Mux213]

I believe TE71 and P-nut have done such swaps. They might be able to shed some lights on it.

This may be a useful link:

http://www.club4ag.com/faq%20and%20tech_...%2020V.htm

[sideways_madness]

cheers thats a really helpful website there!!
any more help appricated!!

[TE71corolla]

okey,check it out
i have done 2 swaps this year(think the only 2 ae86 in holland)

they all say that you can hammer the firewall ,thats bullsh*t
youre distributor still can hit the firewall as well,so just cut a piece out for the distributor

then take youre thermostat housing and take the thermostat out and close that gap with a piece of aluminium or something,and you have ta saw some piece out for the coolant flow

then close the upper coolant hose thing by the ex manifold

then you have to put a 4age 16v waterpump on youre 20v

then you have to made youre own upper cooland pipe on the cylinderhead
and youre cooland system is done without a 700 dollar relocationkit
and it works fine on both cars,never has been overheated!

and you have to modifie the ex manifold a little

and for the wiring you must check http://www.club4ag.com

here are some pics so you can check some stuff out

[sideways_madness]

isnt there a distributor u can buy that will allow it fit without cutting the bulkhead??
think its an electronic one

does any 1 know how much these are and does it make any difference to preformance of the engine??

cheers peeps

[Elitetech]

Rather than cut the bulkhead, you can make a distributor relocation kit DIY if you're handy with a sheet metal folder and have a bit of time!
Follow the link below:

http://www.elitetech.co.uk/ae86_2.htm

[didierae86]

[jondee86]

Ask about on http://www.ae86irl.com as there are a heap of AE86 with 20V
conversions diffing in a carpark close to you

Cheers... jondee86

[banpei]

Elitetech Wrote:Rather than cut the bulkhead, you can make a distributor relocation kit DIY if you're handy with a sheet metal folder and have a bit of time!
Follow the link below:

http://www.elitetech.co.uk/ae86_2.htm

Four and a half years ago kits were either not available or too expensive, but this DIY kit is a very nice solution.
However it makes me wonder though how much more difficult a simple distribution belt replacement would become...