AE86 GTV-Multipoint Cage, Beams, AP Brakes & Brides

[Conrad]

Ok here's the updates from a while ago....


Air box back plate and trumpets mounted.


Air box fitted, lid retainer clips fitted also.





Window slider, door handles, lock and window trims fitted.





Rear window trims fitted, tailgate aero catches fitted.



Hydraulic handbrake, cable handbrake setup



The pedal box needed relocating for the master cylinder clearance against the bulkhead, this was achieved by water jet cutting a plate that mounted onto the original Tilton pedal set mounts on the chassis and then allowed the Tilton pedal set to be mounted on the plate 1" further forward.



And mounted....



That's all for now folks, next up is to finish a few little odds and ends, map it on the dyno and then I will bring it home to finish off the other little stuff like sorting the hole on bulkhead, remount the chassis plate, air box intake hose and scoop, fit side skirts, fit rear bumper, fit front bumper, fit splitter and decide on final paint scheme etc