Clutch release bearing - do you have this part?

[Apolan]

Hey,
i'm looking at this (lower) diagram: http://www.toyodiy.com/parts/p_J_1986_TO..._3101.html

.. and i see there is some sort of a hub that goes between the push fork and the bearing. I think i dont have this. I'm pretty sure the bearing goes straight on the shaft from the transmission, and the fork pushes against the bearing directly when cluch is depressed. Do you have this hub?

And also, i dont have the bearing that goes between the clutch an the flywheel - 33311W on the upper diagram. Do you have this folks?

Man im confused.. i didnt have this things before, and the clutch worked okay.

[apardal]

Apolan, the 33311W is placed on the flywheel/crankshaft. That's why you don't see it.

And the hub you're talking about is most of the times attached to the bearing. The clutch wouldn't work without the hub.

Best regards

[Apolan]

Okay, thank you apardal! I will recheck my bearing, maybe i was just sloppy when inspecting.

[Bean]

apardal Wrote:Apolan, the 33311W is placed on the flywheel/crankshaft. That's why you don't see it.

And the hub you're talking about is most of the times attached to the bearing. The clutch wouldn't work without the hub.

Best regards

confirm that - just replaced my clutch and thos bearings last week

the release bearing is pressed onto the hub which is connected to the fork with the two clips

[Apolan]

Alrighty than!