Bean Bandits Levin 'Globetrotter'

[Bean]

totta Crolla Wrote:Bean the brake master cylinder is from a very late car.
I have the same one, it's good but made from steel as opposed to aluminium and I think that is why it has four fixings instead of two.
From my experience with the same cams as yours you will definately need adjustable pullies, at the recommended setting my exhaust cam was 18 degrees off (advanced) and if yours are the same and you are still using a distributor you may have issues getting the ignition timing right.
They do make good power and on my engine respond well to having increased overlap at TDC
Somewhere around 108 degrees inlet and 104 degrees exhaust :wink:

I got Toda pulleys
Eventually I'll see how much performance I can extract from my setup and if not pleasing enough I'll go a step or two up in the catcam range. First I need to have a base figure though. Not sure how much money I will through into it once finished as my final goal is still a Beams engine so will see how I get on