Carbs for the 4AG

[SekiguchiUeno]

i am think also about to using carburetors,
i am not familiar with electronic and i can buy a cheap set of weber dcoes 45mm.
but i think about this only if i make some power upgrades for the engine, for the stock one is the tvis with ecu better.
the intake is the most problem.
but i have seen an carb intake manifold on this forum
i can make it on cnc milling machine but i have not the time to draw it.
(and i have not an hachi

about the ignition is it a good tip.
and the fuel pump can you use from an lada

an other way is to use the mikuni carb set from an motorcycle.

[SutteR]

SekiguchiUeno Wrote:and the fuel pump can you use from an lada

Lada is coool but it has a mechanical AC pump mounted on its block. How can it work on the 4A block?

Btw...the hachi SR5 also have this kind of AC pump and then I think I will use genuine Toyota parts...

[SekiguchiUeno]

its was an joke:O)

i know that hungarians like ladas and tune em up.
but i have don`t any know how about lada`s

i would like to meet you an see your work on the hachi.

i can translate your hungarian 86 sites, and manuals for the ignition but i must find time for it.

[SutteR]

Hey, u speak Hungarian??? That's great, and very rare!

OFF:
About Ladas: http://www.zsiguli.hu - a great site of a circle of friends (of mine) (also has english version)
ON

My hachi is not so much fun till now, meet sometime later...

[jamiemirror]

2 SekiguchiUeno:

Quote:I can make it on cnc milling machine but i have not the time to draw it.
(and i have not an hachi

I already have the Autocad drawing - my problem here is CNC milling (very bad services).

[SutteR]

jamiemirror Wrote:2 SekiguchiUeno:

Quote:I can make it on cnc milling machine but i have not the time to draw it.
(and i have not an hachi

I already have the Autocad drawing - my problem here is CNC milling (very bad services).

What kind of carbs have you the drawing for? Weber, Dellorto, what?

[jamiemirror]

40s.
Sutter, Weber, Delorto and Solex sidedraughts share the same pattern to intake adapter - so this is universal.
PS: the drawing is made for bigport head (bluetop). I can made one for smallport also.

[SutteR]

jamiemirror Wrote:40s.
Sutter, Weber, Delorto and Solex sidedraughts share the same pattern to intake adapter - so this is universal.
PS: the drawing is made for bigport head (bluetop). I can made one for smallport also.

Sorry, didn't know.
I have bigport... :wink: Starting to look after CNC around here.

[jamiemirror]

Sutter, no need to look for CNC - I already prepared production, waiting unconfirmed request from a club member ( :-)) ) to fulfill my 5-piece quota.
The problems with CNC:
1. You must enter manually (!!!) whole drawing (no Autocad import !!!).
2. You must produce as much adapters as you can at once (to lower the costs - the main cost is CNC programming, see 1.).

[SutteR]

Oh, I understand. Is there any other way than CNC? Something manual... I don't know how the intakes e.g for the ladas are made here but that have to be a low cost something...
I'll ask a few people about it.

Btw. about how much would the intake cost if only 5 pieces are made? I might be able to find someone who also wants this mod.