Rebuilding steering rack, which parts to renew?

[Aram]

assassin10000 Wrote:There's only a 'handful' of renewable parts.

2x bearings on the pinion gear
1x pinion shaft seal
1x rack shaft end bushing
2x tie rod end boots.

with new molybdenium grease and its good to go.

Andrew

I found these partnumbers, the bold ones are specificly for the AW11 rack, which I have, the other ones are for both.
My technical english is not good enough to recognize every item you listed above, but I will try to connect them.
I will make them red, can you confirm if this is ok?

45046-29135 Outer Tie Rod End (x2 LH and RH are the same)
45503-19066 Inner Tie Rod End (x2 LH and RH are the same)
45536-12011 Steering Rack Boot (RH 12/84-1/88, LH 12/84-12/89)
45536-17010 RH Steering Rack Boot (1/88-12/89)
90467-18003 Steering Rack Boot Clip (x2)
90461-10273 LH Steering Rack Boot Clamp
90949-01453 RH Steering Rack Boot Clamp
90363-13001 Pinion Gear Lower Bearing (12/84-9/89)
90363-13004 Pinion Gear Lower Bearing (9/89-12/89)
90363-15003 Pinion Gear Upper Bearing (12/84-9/89)
90363-15015 Pinion Gear Upper Bearing (8/89/12/89)
90311-15002 Pinion Gear Oil Seal
44277-17010 Rack Guide Seat

I also have heard something about spacers, to lenghten the rack a bit.
But I think this is for more steering angle, I found something called the battleversion 2?



The rack will work without this and have the normal steering angle?

Hope you can let me know.

Thanks

Aram