ford type 9 gearbox with 4age engine

[assassin10000]

Did anyone ever make a type 9 or borg warner T-5 to 3sg bellhousing?

Andrew

[Uzelac]

(12-23-2014 01:28 AM)filh Wrote:  Uzelac : on Esa Peltonen site :http://www.esapeltonen.fi/ refering to AE86 parts the gearbox is well called Dogbox (3 models).
I already have bought a Type 9 Quaife box , short ratios , straight pinions and synchros

Yes, you are right, i've seen that.
What confuses me now is my gearbox. It should be KL, but it is synchomesh with helical gears and I don't see one like that on their website. Hmm ...

[filh]

dog box are made with straight cut pinions , Quaife made both straight cut pinions, with dog or synchromesh engagement.
Not many details on Espeltonen site , about gearbox (ratios ? historical version?).
The advantage : it's a direct bolt on .
I guess it would be better to email him .
Phil

[S.K.]

better pics of Toyota 4A-GE -bellhousing bolted to Ford gearbox with homemade adapter...I think I still have adapter drawings somewhere in my garage...

[filh]

very nice part

[S.K.]

It´s not nice drawing, but it helps...thickness is about 22mm.
T=Toyota (threaded holes) F= Ford (straight holes).

Also on bellhousing must make some room for shifter shaft.

[filh]

Thanks S-K nice drawing, with all measurements.
I've receive the spigot bearing (for Ford type9) but it won't fit the Toyota crank.
what solution did you use ?
Thxs
Phil

[S.K.]

If I remember correct I use a 6902RS (28x15x7) bearing.
Toyota spigot bearing is 6001RS (28x12x8 ) and then measure Ford clutch axle diam. (I think it is a15mm).

[filh]

many thanks , your measurements looks correct. thanks for your answer , that will help me a lot .
Totta do you have same size for your spigot bearing?
Phil

[filh]

Spigot bearing problem resolved . Thanks S.K.
Beginnning with Kouki gearbox member, to adapt with Type 9 gearbox mount .
One day , one problem , I hope to get through before first rally ...
Phil