Impreza Group-N project.

[Aram]

Treu, you can achieve that look with other coatings or paints.

[green_boy_91]

loven the black

[einneb]

Aram Wrote:I have no idea, that guy who is helping had it done, and he is a bit hesitant to release info for some reason.

I'll try to find out.

would be nice if you can find out,
i would love to get my suspension parts coated like this.

[Aram]

I would not do that if I were you.
For suspension parts under the car I'd choose a smooth coating.
The reason is that dirt will not stick as much to a smooth surface so this will prevent rust etc.

[Mux213]

Aram Wrote:Lol, thanks guys, I'll pass on the compliments, but he has a Russian girl atm, I think he's happy now.

Tell him to watch: http://en.wikipedia.org/wiki/Birthday_Girl

He'll be over here in seconds

[einneb]

Aram Wrote:I would not do that if I were you.
For suspension parts under the car I'd choose a smooth coating.
The reason is that dirt will not stick as much to a smooth surface so this will prevent rust etc.

hmm oke,
but i still would like to know where i can get those coatings

[Aram]

Few updates, it's getting warmer outside again, so I'm getting back to work.


I did some more grinding on the cooler beams, made some cardboard templates aswell.
But I'm not satisfied with the lower beam, I think I will change that.

Trimmed the side plates a bit:






The templates, I want to make it look stock. :










With the coolers in:





Nice, I like.

[Aram]

Before I can go on with the coolers I need to fix the alternator and steering pump.
I want as much clearance for the shrouding as I can get, which means I need to build everything as close to the engine as I can.

A good start is getting the crank pulley closer to the engine.
But all Subaru pulleys have the space that is taken up by the aircon pump belt, so I needed one made for me.
So I had one made and it clears up a lot of space, about 20mm's.




Close as possible to the engine, I think about 3 or 4mm:






I got a smaller alternator, from 90 to 70 ampere, but unfortunatly the pulley on it was wrong.
I had an aftermarket pulley but that didn't fit either, so I that was fixed.





En viola:

[speed-inc]

You are a sick fabricator.
Can't wait for this to run.

Keep it up.

[cannabolic]

Hey, it's alive again

Are you going to support the lower plate as well?