Vienna Levin Project

[MatthewG]

time for my engine swap....
package is on the way and will arrive in dec.

[MatthewG]

First parts for my engine swap arrived this days:

Complete Engine Gasket Kit
Oil-Pump
Timing Belt Kit & Waterpump
Oil-Pressure
Oil-Temp
Boost-Pressure Gauge
HKS 212mm 6kg Flywheel from Ozone, thanks again mate!
Godspeed Watercooler and fans
Headbolts


I am waiting for:
Exhaust Temp. Gauge
Exedy Stage 2 Clutch Kit
T-50 gearbox parts, Gaskets, Syncros and bearings
Steel Clutch Hose
Flywheel Bolts
New Wipers
Lower Gaskets for Watercooler
and more...

And if god will, on Monday my Engine clip should be in vienna...

I am planing of doing the swap over the christmas holidays and hope you guys will help me with the wiring...

here are some pics from the parts:

[[Walaki]D`Lair]

Dude when your car is ready you MUST come to our next annual meeting Distance is not an excuse, we're in the neighbourhood

[MatthewG]

[Walaki]D`Lair Wrote:Dude when your car is ready you MUST come to our next annual meeting Distance is not an excuse, we're in the neighbourhood

thank you, man! would be a pleasure for me! dont worry about the distance, as long as i got boost, there will be no " to long distance"

greets

[CSM]

Where did you get your oil pump? Is it OEM - 4AGE Gen. III? What´s the part number? Is there a difference to the pumps Gen I. and Gen II?

[ZDoman]

hey man, nice project you have here.
Will you use the aw11 specific parts from the swap? I have a friend who migh be interested in especially the gearbox and the halfshafts.

[MatthewG]

CSM Wrote:Where did you get your oil pump? Is it OEM - 4AGE Gen. III? What´s the part number? Is there a difference to the pumps Gen I. and Gen II?

no its not an orig. toyota part, i bought it from usa. but its true, there are some differences in the oil pumps, i have seen a thread about this, on bill sherwoods HP: http://www.billzilla.org/4agstock3.htm .

when i pull out my gze i will take a look at the orig. partnr. and tell you!

[MatthewG]

ZDoman Wrote:hey man, nice project you have here.
Will you use the aw11 specific parts from the swap? I have a friend who migh be interested in especially the gearbox and the halfshafts.

thank you mate!
u have PM!

martin

[MatthewG]

the never ending story has finaly an end! i have the clip through customs before christmas, but this was a pain....

i picked it up yesterday and start to open the package at 5:00 pm, my plan was just watching and make the first inspection but my friend HaR(ota)ry had an other plan, so at 11:00pm we are ready to pull the engine out, but this will be after the christmas holidays..
i found a few fine bits: aftermarket dampers&springs, trd cap, trd gearbox mount and now i am sure its a LSD gearbox lets see what else is hidden...

so here the pics:



Wish all you guys merry christmas!