AE86 GTV-Multipoint Cage, Beams, AP Brakes & Brides

[Conrad]

So the car went on a little journey, time to get the exhaust system issue rectified.

---

Manifold downpipes shortened and the entire system lifted up. The rear section has now been re-routed over the axle.

[fantapants]

This is excellent... Awesome decision man...

Sent from my HTC_0P6B using Tapatalk

[Conrad]

Sorry, I am suffering from a lack of interest at the moment.

A few bits done....


The list is getting smaller:

Fabricate heel plate for driver to suit pedal box. Completed
Fabricate and fit breather tank for the cam cover vents. Completed
Wire up the wiper motor and configure PDM, function test. Completed
Fit wiper arm and new wiper blade. Completed
Wire up indicators to work from indicator stalk as well as the console switch. Completed
Fit TRD anti-roll bar. (Now bought the required parts)
Fit Roll cage protection on door bars.(Partially)
Fit Takata Harnesses. No
MOT No
Magazine Photoshoot. No
Finished ! No

[Conrad]

One of the last jobs to do is fit the rear TRD anti-roll bar. All the mounting fixtures were missing from the fabricator so I took the opportunity to get some Techno Toy Tuning items to enhance the set-up and give plenty of adjustment in the set-up.

TTT T3 Parts






TRD Anti-Roll Bar (ARB or Sway bar in some countries)



Car jacked up and put on the ramps to make a start




Drop link mounting blocks bolted onto the chassis rails...

[Conrad]

ARB lowering mounts on and the ARB mounted up







Drop links mounted



And finished....

[Bean]

looks good, though I would advise to mount it on the softest setting rather than the mid one. You can't get enough traction at the rear. My friend removed the rear ARB alltogether on his hillclimbing race car

Sent from my SM-T800 using Tapatalk

[Conrad]

The list is getting smaller:

Fabricate heel plate for driver to suit pedal box. Completed
Fabricate and fit breather tank for the cam cover vents. Completed
Wire up the wiper motor and configure PDM, function test. Completed
Wire up indicators to work from indicator stalk as well as the console switch. Completed
Fit T3 ARB parts and TRD anti-roll bar (Now bought the required parts). Completed

Fit wiper arm and wiper blade.
Fit airbox snorkel and filter.
Fit Roll cage protection on door bars. (ongoing)
Fit Harnesses.
MOT
Magazine Photoshoot

[Conrad]

More work done.....

Fit wiper arm and wiper blade. Completed
Fit Harnesses. Completed

Single Wiper arm fitted



Takata Harnesses installed



You can also see a bit of the carbon firbre roll cage protection in this picture.





Remaining jobs....
Fit airbox snorkel and filter.
Fit Roll cage protection on door bars. (ongoing)
MOT
Magazine Photoshoot

[Bean]

3 things, first of all great work as always. Regarding the wiper I would orient it facing straight up (think old mercs) and last but definately not least, you are missing one very crucial point on your to do list: drive the bloody car

Sent from my SM-T800 using Tapatalk

[Conrad]

(05-26-2017 11:35 PM)Bean Wrote:  3 things, first of all great work as always. Regarding the wiper I would orient it facing straight up (think old mercs) and last but definately not least, you are missing one very crucial point on your to do list: drive the bloody car

Sent from my SM-T800 using Tapatalk

Bean,

Regarding the wiper, I tried that but it came over to far on the drivers side, with its current position I get full sweep to the edge of the screen