Trueno Coupe South Africa

[MIGGZFSU]

First test dummy was a success!!!!!!!!

Still needs sanding and touch ups and more cutting, but here you can see the weight difference as well



Sent from my F3111 using Tapatalk

[MIGGZFSU]

More mould making for the Toyota

The inner mirror caps iv sent off to get 3d printed then from there they will be carbon

The headlight cover garnish also sent off to make copies then carbon again

Making the mould for the other side headlight cover
And making a garnish for the trunk lid

And made a mould for the center consol

Sent from my F3111 using Tapatalk

[MIGGZFSU]

And first gear consol done

Needs more trimming and a nice glossy coat of clear

Sent from my F3111 using Tapatalk

[kazi]

What do you make the mould out of?

[MIGGZFSU]

(12-03-2017 02:36 PM)kazi Wrote:  What do you make the mould out of?

I use a gel coat, then a combo of carbon and fiberglass bud with like a 1000 steps between lol

Sent from my F3111 using Tapatalk

[kazi]

Was talking just about the mould itself to make get the shape

[MIGGZFSU]

I use an existing part to make a mould bud

Unless I scratch build from scratch like iv done with this race car
.

Sent from my F3111 using Tapatalk

[MIGGZFSU]

Test fit done on the headlight cover

Sent from my F3111 using Tapatalk

[MIGGZFSU]

Got bored and decide to fit the set of side skirts I had


Sent from my F3111 using Tapatalk

[banpei]

Looks much better!