Cams for a stock 4age 16v

[AE86_Z]

robokill Wrote:this is my engine running:

81.5 mm pistons
standard head gasket
worked ports and valves (also combustion chamber)
catcams last standard valve cam.

264 252 8.5 and 9mm lift

I am running 134.8 WHP and 150 NM

This is measured on the wheels. So anything is possible.

OMG It's almost 170 horsepower on crankshaft. Great result!
Can I see any videos of your car?

[AE86_Z]

Dyno run:




167,11 HP @ 7250 rpm 155 Nm on crankshaft

[[Walaki]D`Lair]

Grats m8! You have an awesome car! ZDoman tuning FTW!

[tolisspi]

What a fuk!
Very good result mate! And you have the oem ecu!
How do you count the crankshaft horsepower?

[AE86_Z]

I think I made a mistake in the calculation for crank. I counted with 25% drive train loss, but as I read on club4ag 20% is a common number.

So my car can do about 160 HP on crank.

[tolisspi]

AE86_Z
I have a 4age tvis.
My plans are like yours. I have a 4agze complete bottom end (pistons, rods, crankshaft ect) of ae101 4agze late version. I want to change the low compression pistons with high compression pistons. What do you think? The others parts like pulley, water pump ect can they fit on the engine? Can i use the headgasket of bluetop?
Do you know brands of pistons? Commercial sites in Europe?
Thanks a lot mate!

[ZDoman]

Video of AE86_Z-s dyno run

http://www.youtube.com/watch?v=hCiQv5ZYKOs

[tolisspi]

Which the differences between:

1.- http://www.rhdjapan.com/jdm-low/TODA-Rac...AE92-51757
2.- http://www.rhdjapan.com/jdm-low/TODA-Rac...AE92-51847
thanks

[cavey]

eh, one is a set of intake and exhaust cam... the second one is only an intake cam.

otherwise they're pretty much the same stuff. One is a set, the other just a single one intake cam for either the AE86 4AGE or the AE92 4AGE (bluetop/redtop?)

Probably the description seems a bit confusing "for both intake camshafts only". The text is just the same as for the set, they just removed the word exhaust from the description.

hope to have helped.

if you want a technical explanation, i'm not your man

[tolisspi]

So, the 1st link includes cams for both exhaust and intake. NOT A set. the prie is for one cam. Simply that cam has the pulley/gear and can use like exhaust (important the gear(?)) and the 2nd link inlude only for intake (not important the gear)
I learn it few minutes ago. Thanks a lot mate.