Mikzu's 4A-GZE project

[Mikzu IV]

Jousi Wrote:Hi! Could you help me a little with ignitor connection? I have GZE ignitor but i have to wire it from ecu and on the web there are not enought info about those wires. There are those 2 connectors on the ignitor, and as far i know, smaller 2 wire connector are outputs for coils, black for coil 1,4 and blue for coil 2,3, if i am right...
But the bigger, with 5 wires are totally blank for me. In all wiring diagrams they show only three wires going to it, and the colors arent same on the ignitor side. I have colors on the upper row, left to right: brown, grey, red. Under: yellow, white.

Could you tell me what are colors (and meanings if you know) on the engine wiring loom whitch connects those colors?

Moro.
here you go:

purpose / designation / color on igniter / color on wiring loom
signal, igniter -> ecu:/ IGt - / RED / black
signal, ecu -> igniter:/ IGf / GREY / black&yellow
IGd (AE101 IGa) / WHITE /black&orange
battery:/ +B / BROWN / black&orange bigger
tacho:/ TAC / YELLOW / black

coil1:/ IG1 / BLUE / black&blue
coil2:/ IG2 / BLACK / black

hope it helped you.

heres how to wire the 7mgte igniter (part: 89620-14440) to mach the gze igniter: http://www.club4ag.com/faq_and_tech_page...%20DLI.htm

[Jousi]

Yes, that helped a lot!
Later on last evening i opened the ignitor and inside of it there where last letter in some of the wires meaning its purpose but not in all contacts.
Thank you very much!

Kiitoksia paljon!