oz 86 my toy my way :)

[fantapants]

hey guys, thought i woul throw a little info up there

so the last engine fell through sucked are, but never mind, ended up getting over it and picked up my new one this weekend...



into the back of the ute and off home

second trick was how to get it out of the ute by my self ....



hooraa! these things are rad!



mm floating edition...

then onto my next purchase... yeah i didnt think this through very well..



engine stand. I dont know what i was thinking but i had planned on just sitting it on the ground i think...

pulling useless shit off....



ie this entire side...



and manifold off.... room for quads

General check over, i dont really know what im looking at, but the engine seems clean. inside the sump is clean as, no gunk, no crud... from the top same deal, everything is VERY shiny and clean.





factory ports look pretty good too

And then it started going down hill.

not too bad, but i managed to snap the ball head off of a allenkey in one of the sump bolts. its now stuck... sooo not sure how im going to move foraward on that one.

As this engine didnt come with a gearbox, im goin to have to do some mixing and matching.

the plan so far appears to be 2s bellhousing, w58 gearbox and custom tail.

The clutch will be a jun or trd lightweight flywheel, and probably excedy hyper single clutch, not looking forwadr to the bill... though its cheaper than a full trd setup i have seen going for like $2g aus at a VERY special price lol.

also not sure on exhaust manifold. This engine didnt come with the factory manifold which i had planned to use as its meant to be an okay bit of gear. So im waiting for someone to say yay or nay to wheather the altezza exhaust, am or oem would fit the ae86. hen it will most like be toda 421 manifold or custom 421 based on a pic of glens set up...



id love to do a blatant copy, but might have to do some questimation. Y are these soo good? this is the guy punching about 200rear wheel kw NA out of his beams.

also got some other goodies sorted...



custom drilled 280 x 30 rotors.



custom brake lines for the z32 calipers



the biggest sanga EVER!!!

so the list stands at...

2s bell housing
appropriate starter motor... will try the one from my 20v first.
flywheel - jun
clutch - excedy hyper single
adaptronic, loom and vidiguage attach
blacktop quad throttle setup
adaptor beams to quads


question... the beams run a returnless fuel rail. Im ok with that just need to check my understanding.i just need to put a relief valve from after the pump to return to the surge tank set at 62psi. How would this be setup you think?? where would i track something like this down?