probs installing Battle Version #2 kit, please help

[assassin10000]

cj Wrote:1. Is the so called "stopper" (the large ring) supposed to be loose, when fitted above the larger bv extension? I am afraid it might move inside the rack and get stuck somewhere in-between the rack teeths. That might block the rack? Why isn't it made as one whole part with the extension?

2. What is the proper way to do the alignment after the installment? Can it be done without aftermarket outer tie rods?

Also how should i compensate the remaining 10,5 mm? Should i modifie my rods by engraving addtional tread and how much on which side?

1. Stopper can't go into the rack. It is supposed to be loose on the BV kit. Leave it on as it takes up the slack and prevents you from going off of the OEM teeth and to where you will have no steering control.

2. OEM tie rods should adjust fine. With the #2 kit you need to 're-center' your steering rack based on the new 'overall' length with the kit. That way you get equal amounts of turning/angle on each side.

3. If necessary you can tap additional threads into the outer tie rods.

Andrew