intake runner lenght with ITBs discussion

[Bean]

can't look at the thread as I'm not registered member... but by the looks of it he uses the T3 stacks so 75mm so that'll be a total of 317mm incl. the plywood so similar to my intended setup with the 90mm stacks.

if my calculations are close to the endeffect this should boost peak torque as I'll be expecting peak torque around that area with my future cams...

insulating the runners from the heat of the head sounds like a good idea although I'm not sure if it has a great effect - especially running open stacks... but it's an easy test so I'll keep that in mind especialy as I'll be running an airbox to have a nice fresh air supply (and a bit more length as well)

if all goes well I'll be able to supply more info mid to late summer still trying to source some more money to build a fresh bottomend to go allong with the spare head but that's way into the future especialy if I want to make some progress with my other project too...