|
help 4age wont rev!?!?
|
|
06-28-2010, 10:39 PM
Post: #5
|
|||
|
|||
|
by idl switch you mean throttle position sensor is it? ive tried at at different settings but it makes no difference. when i cross the connector between t1 and e1 it doesnt cut back the revs/timing at all
when i snap the throttle open it will rev up once ok but after that it will just retard and fail to rev up at all. ive checked wiring on all sensors and its correct, plug leads are correct and new, ive tried different fuel pump, distributor, throttle position sensor and still it wont rev. ive ran diagnostics and get codes 7, 8 and 11 |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
help 4age wont rev!?!? - ep71 - 06-27-2010, 06:11 PM
[] - PatrickAE86 - 06-27-2010, 06:44 PM
Engine running backwards ?? - jondee86 - 06-28-2010, 10:21 PM
[] - ep71 - 06-28-2010 10:39 PM
Smooth transitions are good :) - jondee86 - 06-29-2010, 02:33 AM
.... don't blow :) - jondee86 - 06-30-2010, 03:26 AM
The dilithium crystals are low Captain.... - jondee86 - 06-30-2010, 10:27 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Raising the rev limit on stock ECU | fax0815 | 2 | 10,703 |
08-31-2015 02:04 PM Last Post: gon |
|
| 4age 16v oem ecu rev limiter research | ditn | 18 | 27,776 |
06-22-2015 08:02 AM Last Post: ditn |
|
| Start wont turn over after installing radio | MC_JP | 6 | 9,578 |
09-22-2014 11:13 PM Last Post: izanagi |
|
| High rev problem | stratosTRD | 6 | 9,429 |
07-03-2013 12:05 AM Last Post: jondee86 |
|
| Mikuni carb help just wont balance | megabob | 3 | 5,061 |
01-01-2013 10:32 PM Last Post: allencr |
|
User(s) browsing this thread: 4 Guest(s)