Aram's 3SGE Beams Levin Coupe

[Aram]

Next was the rear bumper and rear arches.
I wanted a nice finish to them and a good fit.
We placed the bumper a bit higher on the car so the gap between the body and bumper would not be so massive.

That meant the shape near the wheel arches had to be made a bit different than standard, but in my opnion it will turn out alot better looking.

Here is what we cut away:



The gap, I will widen the bumper to match later:




On this side the welder cut a bit to much arch away a while back, so he can tidy it up now:




And also I started brushing away the kit and dirt from the panel overlap, so we can seam weld the chassis.
Bottoms up, because this is the worst part to clean, let's get it over with !:








All the bolts and brackets are now at the plating shop, to get a nice new shiny coat, hopefully they will be done soon!