Using Honda springs for coil overs

Threaded Mode | Linear Mode

Using Honda springs for coil overs

04-23-2011, 12:21 AM

Post: #18

NoHachi Offline

Super Moderator

Posts: 2,902
Joined: Sep 2004
Reputation: 0

I run at oxcart heights. Dunno how to give you an exact number (all reference points are tweaked), but basically it sits on shortened housings, with ride heights that put the dampers near 50% bump, 50% rebound travel at static ride height. There is about 5cm of bump travel available now, without bump stops.

A wheel to steer the front of the car
A pedal to steer the rear

« Next Oldest | Next Newest »

Messages In This Thread

Using Honda springs for coil overs - roman - 04-18-2011, 08:49 AM

[] - Ivan141 - 04-18-2011, 09:32 AM

[] - roman - 04-18-2011, 10:17 AM

[] - Uzelac - 04-18-2011, 10:43 AM

[] - roman - 04-18-2011, 11:58 AM

[] - Uzelac - 04-18-2011, 12:18 PM

[] - roman - 04-18-2011, 12:49 PM

[] - Ivan141 - 04-18-2011, 02:12 PM

[] - NoHachi - 04-18-2011, 06:05 PM

[] - NoHachi - 04-18-2011, 06:07 PM

[] - roman - 04-19-2011, 10:15 AM

[] - NoHachi - 04-19-2011, 12:15 PM

[] - roman - 04-19-2011, 01:32 PM

[] - NoHachi - 04-19-2011, 03:49 PM

[] - roman - 04-20-2011, 04:12 AM

[] - NoHachi - 04-20-2011, 08:00 AM

[] - roman - 04-22-2011, 11:36 PM

[] - NoHachi - 04-23-2011 12:21 AM

[] - NoHachi - 05-07-2011, 12:15 PM

[] - NoHachi - 05-07-2011, 12:19 PM

User(s) browsing this thread: 2 Guest(s)