co idle mixture - discussion

[Apsogos]

fax0815 Wrote:Sounds to my like that during changes on the fuel system, your engine is getting a lot more fuel than before, hence the higher CO. Could have been things like block filter, lazy fuel pump,... nothing to worry about.

Setting the CO up with an unstabe ilde is kinda tricky, but as long as your´re in the factory specs (sorry can´t remember them right now!!)and the tolerance range I whouldn´t worry to much.

You can allways receck it maybe at night or early in the morning is colder outside, or disconect the fan for the time of the procedure?

hello my friend! thank you for your fast reply....i dont have unstable idle..
i have unstable co,meaning e.g from 1,85 % to 1,20% and then circle again.... the oem settings are 1.5% + - 0,5% ,my resistor is new , i replaced it 2 years ago.

p.s. unfortunately i cant check it anytime i want because i dont have a CO analyzer at home. .I should go again to a shop to check it again.(i was thinking if there are cheap portable co analyzers to buy ? )