OST-020: Variables

[oldeskewltoy]

oldeskewltoy Wrote:Valves to lap in (then back cut), chambers to deshroud, and a few goodies the client will be bringing over for final assembly


More to come......

Well... the lapping went fine... but the same can not be said about the back cut. To make a long story short, the client now has/had a reason to purchase the Supertech valves he wanted........



The Supertech valves were then lapped into their respective seats. The above view was immediately after I checked chamber volume... all @ 37cc....



....just like the one below



You can see that the brows that normally are part of the chamber have now been blended away.

Here is a 3 panel, in this view you can see the heads transition.



Note the deshouding of the chamber from the middle view to the bottom view. Besides the chamber work, the bottom view shows the minimized valve guides, and my typical bowl work.


More to come.......