Webber DCOE 45mm for 200hp

[kpretro84]

rene Wrote:if you have no expense with engine building

buy a engine from a engine builder cheaper in the long run

but 200 hk is expensive head work, you have to fit bigger valves to get over 180 to 190hk

big lift cams again machining off head and followers off shim under buket type

but it is a +10k euro engine you are starting on

so if this you first engine forget it, you just get disappointed

Alright then guys i did read somewhere 45mm webbers are fairly too big for N/A suppose to be 40mm if i was just to swap from efi to carbs 45mm are for some after market cams and modifying things it says. 45mm maybe too big to tune so any suggestion for what type of cams i should get to suit webbers 45mm? ill stick with 160hp then? so ill throw in some after market valve springs and cams and juts rev the shit out of it see what i get? i dont know much about cams so which ones should i go for guys thanks