Webber DCOE 45mm for 200hp

Threaded Mode | Linear Mode

Webber DCOE 45mm for 200hp

05-18-2013, 02:46 AM

Post: #17

kpretro84 Offline

Member

Posts: 50
Joined: May 2012
Reputation: 0

Also i just had a read again on Bills page on the 160hp mark doesnt say much on carbs sadly Just this A quick note - the 4AGE that I have in my AE-86 Sprinter has 288° cams, an aftermarket computer, 10.5:1 compression, and a small amount of head work done. It makes about 160hp with a completely stock bottom end. It ran to 8,500rpm without any problems.

« Next Oldest | Next Newest »

Messages In This Thread

Webber DCOE 45mm for 200hp - kpretro84 - 05-17-2013, 11:30 AM

[] - Ivan141 - 05-17-2013, 11:44 AM

[] - kpretro84 - 05-17-2013, 12:29 PM

[] - Bean - 05-17-2013, 03:08 PM

[] - einneb - 05-17-2013, 09:01 PM

[] - ditn - 05-17-2013, 09:07 PM

[] - totta Crolla - 05-17-2013, 09:57 PM

[] - robokill - 05-17-2013, 10:38 PM

Re: Webber DCOE 45mm for 200hp - oldeskewltoy - 05-18-2013, 12:41 AM

200hk - rene - 05-18-2013, 12:46 AM

Re: Webber DCOE 45mm for 200hp - kpretro84 - 05-18-2013, 02:07 AM

[] - kpretro84 - 05-18-2013, 02:09 AM

[] - kpretro84 - 05-18-2013, 02:12 AM

[] - kpretro84 - 05-18-2013, 02:15 AM

Re: 200hk - kpretro84 - 05-18-2013, 02:32 AM

[] - kpretro84 - 05-18-2013, 02:36 AM

[] - kpretro84 - 05-18-2013 02:46 AM

[] - ditn - 05-18-2013, 09:18 AM

[] - totta Crolla - 05-18-2013, 11:03 AM

[] - einneb - 05-18-2013, 12:04 PM

[] - totta Crolla - 05-18-2013, 01:49 PM

[] - kpretro84 - 05-19-2013, 01:32 AM

[] - einneb - 05-19-2013, 11:08 AM

[] - robokill - 05-19-2013, 01:11 PM

[] - Vortrex - 05-25-2013, 03:50 PM

[] - Rascal21 - 05-25-2013, 04:55 PM

[] - S.K. - 05-25-2013, 06:37 PM

User(s) browsing this thread: 4 Guest(s)