cams cams cams
|
08-30-2013, 10:05 AM
Post: #8
|
|||
|
|||
NoHachi Wrote:Wheel-hp will vary as much as 20% between dyno's and is as useless asYes, understood. But providing you use the same dyno each time, you should be able to measure any change (+/-) due to modifications you have been making. I can't think of any other reason for using a dyno And personally, I would never use an inertia dyno when there was a hub dyno available. [plug]And being designed and built in NZ means Dynapak hub dynos are used by all our top tuners.[/plug] Cheers... jondee86 |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
cams cams cams - megabob - 08-29-2013, 01:31 PM
[] - jondee86 - 08-30-2013 10:05 AM
[] - Alex170984 - 08-30-2013, 04:53 PM
[] - oldeskewltoy - 08-30-2013, 08:53 PM
[] - oldeskewltoy - 09-04-2013, 09:17 PM
[] - totta Crolla - 09-04-2013, 09:25 PM
[] - totta Crolla - 09-04-2013, 10:31 PM
[] - oldeskewltoy - 09-04-2013, 11:53 PM
[] - totta Crolla - 09-05-2013, 12:48 AM
[] - Alex170984 - 09-12-2013, 02:49 PM
[] - Alex170984 - 09-12-2013, 02:51 PM
[] - Alex170984 - 09-13-2013, 02:56 PM
[] - oldeskewltoy - 09-13-2013, 07:30 PM
[] - oldeskewltoy - 09-20-2013, 07:44 PM
[] - totta Crolla - 09-20-2013, 11:44 PM
[] - Alex170984 - 09-23-2013, 03:11 PM
[] - totta Crolla - 09-24-2013, 10:44 PM
[] - Alex170984 - 10-24-2013, 01:17 PM
[] - Alex170984 - 10-24-2013, 04:47 PM
[] - oldeskewltoy - 10-24-2013, 10:46 PM
|
User(s) browsing this thread: 20 Guest(s)