Ring & pinion ratio.

[jondee86]

(06-24-2014 08:53 AM)izanagi Wrote:  [quote='jondee86' pid='162334' dateline='1403567791']
What do you mean by that:
If the gears appear to be
in good condition, you could try adjusting the contact patch, or just put
up with the noise, and hope that it settles after a while. ?????

I should set up the ring much closer of the pinion ?
With the same method showed in the factory service manual ?

When you dismantled the diff there should have been a wear pattern
(contact patch) visible on the crownwheel teeth. Providing the contact
patch was correctly placed on the face of the tooth, you should have
tried to put the diff back together with the contact patch in the same
position. The procedure is in the FSM, and some nice pictures here...


http://www.pirate4x4.com/tech/billavista...ear_Setup/ Scroll to the bottom of the page.

Did you adjust the contact patch during final assembly of the diff ?

Cheers... jondee86