My panda ae86 build

[Ellzbmx]

Lots been going on over this long weekend
After changing some seals on my dizzy it was leaking still so I replaced it with a refurbed one problem solved



Took my panhard bar off to clean up and grease to find it was revolver pretty stoked



Pulled my speedo drive out to replace as speedo didn't work the clip to hold the drive had gone on inside scoring the inner side whitch was annoying as is scratched up my new one so I drilled it out and filed problem areas down whitch solved it



Cleaned the horn up and put it back on



Scrubbed the underside and applied some etch primer and underseal to hopefully stop her rusting



Done
Polished up a few bits



After all that I pulled her out today for a little drive


Off to paint a week today