|
DIY: Hopeless project.
|
|
08-23-2015, 05:36 PM
(This post was last modified: 08-23-2015 05:37 PM by Rascal21.)
Post: #87
|
|||
|
|||
|
RE: DIY: Hopeless project.
Yeah I even made a secure earth from there to the chassis to make sure.
I got a multimeter and checked Injectors > ground - Good. Injectors >ECU (NO.10 and NO.20 pins on ECU Harness side to Injectors Harness side) - Good ECU Harness side > Igniter Harness side (ECU pin#5 called IGt on middle plug) - Good. I checked one of the Engine Revolution Sensor wires too (Pin called G1, From ECU harness side to the distributor Harness side) which also looked good. Will check the other two to make sure. If anything is wrong with the harness it must darn near be here because if ECU does not sense that engine is cranking then it wont give the engine any fuel or spark. Glad to see that all the wires I`ve checked so far are 0.00 Ohm resistance exactly, not 0.01 or 0.02, but 0.00, healthy wires and pins is good stuff 
1x AE86 84` Zenki Coupè Levin 4A-GE 20v 1x AE86 83' Zenki Coupe Levin 4A-GE 16v 1x TA60 82' Sedan 2T 8V 1x TA40 78` MK1 Zenk/Pre-Facelift Wagon 4A-GE 16v |
|||
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 4 Guest(s)