Krullibulls Ae86 BEAMS is the only way

[krullibull]

Things haven't being standing still even if it seems that way here.



Finished the gearbox tunnel. It's not pretty but it'll work, first time I do any extensive metal fabrication on a car.



My flywheel and clutch arrived as well so now the gearbox is mated to the engine for some time I hope



Measured up the driveshaft, not a huge difference.





Started sorting out the loom. There was quite alot that could be removed.

Debating which way I should go with the loom, I have 3 options that I can do.

1. Use a grommet trough the firewall and just use crimp joints with heatshrink between the engine and Link wires

2. Use a grommet trough the firewall and use all of the link wires and re pin the connectors on the engine.

3. Use a Multipin connector on the firewall, some of the engines wires needs to be extended tho. And I'm worried of interference with the shielded wires.

In all options the wires will be in sleeves ofc.