Krullibulls Ae86 BEAMS is the only way

[krullibull]

Took the car out for a drive last weekend, lots of noise, lots of vibrations and lots of fun .

But when I made a quick stop to check fuel pressure (bad wire to the fuelpump) I noticed that the clown adapter i made for the oil pressure and temp was leaking. Thinking that it probably only needed tightening I put a spanner on it and it came off!





I was too greedy when I drilled out the hole but it looked like there was much more material left then it actually was. Had to plug it up with a earplug for the tow back to the garage.



I remade it today with a Autometer steel adapter and tapped the oilfilter house so I could fit the oil temp which wasn't working in its previous location.



Then I took it for a drive to fill her/him up. Some small things left to iron out. Exhaust is probably hitting the car and I think the driveshaft might be vibrating. The car also desperately needs new paint.

Also need to fit the IAT sensor and find bigger injectors from a St215.

// Johan