Project from Denmark

[Vaptor]

A bit more rust work done

Was not quite finished with the rear pocket, forgot all about this small piece, that needed some work.



After a bit work, it was ready to be put back on the car.



When I cleaned the inside of the car, I noticed some rust along the inner wheel house, so took of the reinforced plates to have closer look. And it was a pretty site



After a good cleaning, I could see the parts that needed to be cut out, in order to remove all the bad metal.



Replaced the missing parts, with some fresh metal.



After some welding and grinding, the reinforcement plates where back on the car again.



Now there are no more rust, that hinders me from putting back some of the new body panels I have, can't wait