EUDM gauge cluster

[Project D]

Just wanted to provide the correct information on this.
The 2 connections on the speedometer are not there for the needle (who work purely on the eddy current principle*) but are connected to a reed switch to give you speed signal to the ECU.
The pin 10 on the cluster goes to ground and the pin 11 go to the ECU Pin n°10 on the 14 pins connector.
It give you 2548 pulses / km (4 pulses / cable rev) or in other words multiply the frequency output by 1.42 and you get your speed in km/h.

*the needle "drive":


Now I would be very interested to see the speedometer from the middle east or the JDM version to see how the implemented the switch for the speed chime.