|
CR Variables
|
|
04-22-2018, 11:38 AM
Post: #10
|
|||
|
|||
|
CR Variables
so you'll end up with about 9.3:1 assuming your 36.3 are correct. I can only guess that both head and block were skimmed before. with some headwork you could bring it down a little but not much more than 0.1. every 0.1mm of additional HG would lower CR too by about 0.1. Just live with it and use good fuel.
Sent from my SM-T800 using Tapatalk AE86 ex-daily |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
CR Variables - Alex170984 - 04-20-2018, 12:02 AM
RE: CR Variables - Alex170984 - 04-20-2018, 11:02 AM
CR Variables - Bean - 04-20-2018, 05:14 PM
RE: CR Variables - Project D - 04-20-2018, 10:53 PM
CR Variables - Bean - 04-21-2018, 08:39 AM
RE: CR Variables - Alex170984 - 04-21-2018, 11:01 AM
RE: CR Variables - Project D - 04-21-2018, 02:32 PM
CR Variables - Bean - 04-21-2018, 05:38 PM
RE: CR Variables - Alex170984 - 04-22-2018, 11:04 AM
CR Variables - Bean - 04-22-2018 11:38 AM
RE: CR Variables - oldeskewltoy - 04-23-2018, 06:04 AM
RE: CR Variables - Dave W - 04-23-2018, 03:00 PM
CR Variables - Bean - 04-23-2018, 05:02 PM
RE: CR Variables - Dave W - 04-24-2018, 01:47 PM
RE: CR Variables - oldeskewltoy - 04-30-2018, 05:48 PM
RE: CR Variables - Project D - 04-30-2018, 06:32 PM
CR Variables - Bean - 04-30-2018, 07:38 PM
RE: CR Variables - oldeskewltoy - 04-30-2018, 08:44 PM
|
User(s) browsing this thread: 2 Guest(s)