Some wiring help needed
|
05-16-2019, 11:36 PM
(This post was last modified: 05-16-2019 11:39 PM by jondee86.)
Post: #5
|
|||
|
|||
RE: Some wiring help needed
Wires come out of the engine wiring loom where it runs across the
firewall and drop down to under the car. There are two pins high on the filler side of the gearbox, and those wires should have female bullet connectors on the end. The wires are only in the engine loom for 15cm and then run up into the big square(ish) plug that connects to the ignition switch etc. That is for RHD, if you are LHD the layout might be different. Turn the ignition ON and touch those two wire together... your backup/reverse lights should turn ON. Cheers... jondee86 The reasonable man adapts himself to the world; the unreasonable one persists in trying to adapt the world to himself. Therefore, all progress depends on the unreasonable man. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Some wiring help needed - DJexor - 05-15-2019, 11:22 PM
RE: Some wiring help needed - Ivan141 - 05-16-2019, 10:04 AM
RE: Some wiring help needed - DJexor - 05-16-2019, 12:12 PM
RE: Some wiring help needed - Ivan141 - 05-16-2019, 02:46 PM
RE: Some wiring help needed - jondee86 - 05-16-2019 11:36 PM
RE: Some wiring help needed - DJexor - 05-18-2019, 01:50 PM
|
Possibly Related Threads... | |||||
Thread | Author | Replies | Views | Last Post | |
Tail light wiring... | Mylesmck | 4 | 965 |
02-02-2024 12:36 PM Last Post: Mylesmck |
|
Lambda sensor wiring | sam3007 | 10 | 4,340 |
05-23-2022 10:00 PM Last Post: The Doctor |
|
Help needed | totta Crolla | 3 | 3,856 |
05-15-2020 10:07 AM Last Post: totta Crolla |
|
4A-GE wiring engine to chassis connectors | Lykowsky | 4 | 6,901 |
06-20-2019 11:38 AM Last Post: Lykowsky |
|
Help needed: is it 1 way or 1.5way LSD | Dino86 | 2 | 3,576 |
05-17-2019 09:08 AM Last Post: Ivan141 |
User(s) browsing this thread: 4 Guest(s)