Mux213 Levin GTS

[Mux213]

Pictures will follow soon but here's a small update of yesterdays work:

When I was at robokill on saterday I found a few spots of rust in the boot area. I sanded those down yesterday and got rid of all the rust and sprayed it in with some sink stuff just for a temporary stop. One spot isn't much of a problem, just where the floor of the boot meets the rear of the car, just need to weld some more steel in.

But on my left strut tower there was a tiny bit of rust showing, I grinded and grinded and grinded and eventually found out it almost went straight through! Its still a small spot, not much then a cm2 but it was deep! It's in a hard to reach spot aswell

Final spot I found was in the bit where the jack is stored, in the back there is a big rust hole Its not a hole that went to the outside, I still need to figure this out, because that place is full of moisty dirt and stuff, really sucks.. I'm gonne need to do more work on that later

Also I started work on my sidelights. I got some sidelights with blinkers in them from Japan. A little disappointed about the state they were in I tried to replace the black part on my lights with the clear orange part from these sidelights. Removing the black part turned out to be a hard deal as its glued in tight and heating it up seemed the only way to go. I finally got them loose, and then I ruined the clear lens So thats one side light ready to be thrown away..

So I've desided to cleanup the new sidelights. I've mounted them on my car for now as they are because I've ruined my normal side light.

I'll be taking them off and cleaning them up during the week. The biggest thing I need to do that I'm not sure off is take off the clear lens and spray the inside silver. RIght now my left blinker is silver inside and my right is black (the silver seems to have warn away). sucks...

Awell something to keep me busy