Mounting 4agze

[Hen]

It's not too hard to do yourself.

- Get a good wiring diagram (Techdocs at http://www.toymods.org.au or through club4ag.com)
- Strip the casing off all the looms
- Work out what each wire is for and how much of the ZE loom you will need to use (It should be suprisingly little)
- Cut the plugs you will need off the loom (leave a few inches of trailing wire)
- Plug the plugs onto the engine
- Mount your ECU somewhere nice
- Run each wire from the back of the ECU to the plug on the engine (shorten the wire or add extra sections as needed)
- Splice any body wiring needed (ignition power, AC switch, etc) into the loom
- Start it up and enjoy that SC torque

Yes it is a bit of a bitch of a job, but well worth it. If anything ever goes wrong you will know exactly how to fix it.

And you can NEVER label enough things when you are pulling a loom apart.

Hen