Replacing oil cooler line

[dreja]

Hi,

I've noticed the oil at the point where the oil cooler hose connects to sump. I have tightened the clip, but there is still leakage.

The leakage might be also from the other source (top of the sump, etc.) flowing to mentioned point...

The oil cooler hoose looks like coaxial cable - it is covered with "plastic" shield.
I'm wondering if I can replace the hoose with a normal rubber hose (without shield), used for fuel lines.
For e.g. Good Year fuel/emission hose with same dimensions, max pressure 50psi, but without shielding.
I found out that I have to use the original clip, as others (I've tried 2 standard clips) don't fasten the hose enough - although I tighten them at maximum force, the hose is still moving