DIY: 4age Valve Stem Seals.
08-07-2007, 06:54 PM
Post: #3
 
Ivan141 Wrote:Nice write-up there.. my own engine is also wasting a lot of oil at the moment.. but I'm just rebuilding my spare engine ground-up so I know it'll be good when finished.

The big question I have for you is: how much difference did the new seals make?

Just finished this last friday night at 10:11pm. Took a shower and took it out... No smoke from the tailpipe at stop lights anymore, and I haven't seen anything on startup yet. I've been looking for it too. My car has an alarm w/remote start, so I stand at the left rear of the car and look for it.

So the difference was immediate and definately a noticeable improvement.

When I changed my oil with less than 1500k mi I only had 1 3/4 qts left... scary since it was parked from the weekend before after I had taken it out and absolutely drove the piss out of it. Huh

Granted it was accelerated eating of the oil due to high rpm use, bad valve seals will suck oil when you get off throttle and a vacuum is created in the combustion chambers so drifting/driving hard makes oil usage WAY worse.

Andrew
Find all posts by this user


Messages In This Thread
[] - Ivan141 - 08-07-2007, 06:21 PM
[] - assassin10000 - 08-07-2007 06:54 PM
[] - jos 4 age - 08-07-2007, 08:30 PM
[] - banpei - 08-07-2007, 08:43 PM
[] - Ivan141 - 08-07-2007, 09:50 PM
[] - assassin10000 - 08-08-2007, 09:24 PM
[] - Ivan141 - 08-08-2007, 09:34 PM
[] - assassin10000 - 08-08-2007, 09:57 PM
[] - Ivan141 - 08-09-2007, 05:19 PM
[] - assassin10000 - 08-09-2007, 10:46 PM
[] - jos 4 age - 10-18-2007, 07:49 AM
[] - apardal - 11-12-2007, 12:58 PM
[] - assassin10000 - 11-19-2007, 06:30 AM

Possibly Related Threads...
Thread Author Replies Views Last Post
  4AGE Valve Buckets Scored Steller Engineering 2 849 10-06-2023 05:34 PM
Last Post: Steller Engineering
  20 Valve Blacktop smoking after engine flush - why? RolanTHUNDER 2 1,313 11-30-2022 12:09 PM
Last Post: RolanTHUNDER
  HKS valve springs totta Crolla 3 2,113 05-25-2022 10:24 PM
Last Post: oldeskewltoy
  DIY: a quick outline on why & how to set pinion angle. assassin10000 9 18,085 12-21-2016 10:28 PM
Last Post: ditn
  Valve clearance leon205gti 7 8,534 11-25-2016 03:24 AM
Last Post: oldeskewltoy

Forum Jump:


User(s) browsing this thread: 6 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication