better answer my ? or i'll send bush to "liberate"
08-16-2007, 06:58 AM
Post: #1
better answer my ? or i'll send bush to "liberate"
just kidding

i do have questions though, i posted this @ club4ag, but didn't get a

response.

i m trying to hunt down a 4agze for my ae86

and i have searched the ref section bout the 4agze, it says 4agze is found in the 1st gen

mr2, ae92(?),ae101(?) what years are those?

the ae92/101 are fwd, does this make a difference if u r planning to swap into an

ae86(rwd)?

the mr2 is rwd with mid engine layout, can the 4agze from the mr2 swap

easier into the ae86 than the fwd 4agze?

and the tranny, i have the sr5 tranny. this is a quote from the 4ac to 4ag swap write

up about the tranny:

"Clutch fork and fluid line locations and bell housing (GTS and SR5 has opposite
side clutch fork and slave due to the differences in the exhaust runner location
and is extremely important not to run fluid lines next to exhaust systems)#

Transmission is the same unit as the GTS (T50C), however the speedometer gear
is different, and must be replaced to read correct speed on the cluster. (due to
different final drive ratio)"

i understand to get accurate speedometer readings u need to replace that gear, but

the clutch fork situation. what is that?

can my sr5 tranny clutch fork be made to work with a 4agze?or do i have to get a

whole new GTS tranny.

point me in the right direction please

Banging head
Find all posts by this user


Messages In This Thread
better answer my ? or i'll send bush to "liberate" - foster - 08-16-2007 06:58 AM
Too many questions !!!! - jondee86 - 08-16-2007, 08:41 AM
[] - Mux213 - 08-16-2007, 09:28 AM
[] - robokill - 08-16-2007, 11:22 AM
[] - foster - 08-17-2007, 02:35 PM
[] - banpei - 08-17-2007, 05:09 PM
[] - RBpoweredSileighty - 08-17-2007, 05:16 PM
[] - foster - 08-18-2007, 05:07 PM
[] - RBpoweredSileighty - 08-18-2007, 07:18 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  7" rims or 8" rims? Lauren 7 8,527 05-13-2012 06:04 PM
Last Post: Lauren
  why do you use "roll center ajuster"? leckter 15 18,002 02-07-2012 07:04 PM
Last Post: Bean
  T50 - Gearstick plastic bush? byd1380 7 7,394 01-31-2012 03:59 PM
Last Post: byd1380
  Lets play "Guess that sound!" aka diff problems Apolan 6 6,977 08-28-2010 01:19 AM
Last Post: Apolan
  Supertech Valve are they better than stock pernati 7 6,642 11-02-2009 03:35 AM
Last Post: Chrisso

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication