|
head skiming/size headgasket/hks f-con!
|
|
04-07-2008, 05:28 PM
Post: #2
|
|||
|
|||
|
If you are using 272´ cams it wil be a good idea to raise the compression ratio for about 11:1 I have experince that the standart piston are good for 11.5:1, but then you have to plan the engine block and modify the piston.
If you shim the head just until you reach the small water holes, and using a 0,8 TRD gasket(not 0,5 ) I think you would get about 10.8:1 compression ratio . I hobe you undestand my bad englich writing. http://www.bjerre-rally.dk |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
head skiming/size headgasket/hks f-con! - nick - 03-30-2008, 03:54 PM
[] - Martin Bjerre - 04-07-2008 05:28 PM
[] - oldeskewltoy - 04-07-2008, 08:45 PM
[] - oldeskewltoy - 04-09-2008, 05:09 AM
[] - oldeskewltoy - 04-10-2008, 06:17 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Fitting Air Con (No PS) to LHD AE86 | pack | 7 | 4,025 |
01-07-2024 11:36 AM Last Post: CCB |
|
| HKS valve springs | totta Crolla | 3 | 2,124 |
05-25-2022 10:24 PM Last Post: oldeskewltoy |
|
| HKS Legal exhaust | Nakilad | 2 | 4,639 |
07-31-2019 10:00 AM Last Post: Nakilad |
|
| HKS 260 8.0 Cam Card | d3nso | 5 | 6,856 |
02-14-2018 08:29 PM Last Post: oldeskewltoy |
|
| Shim size for AM cams | kazi | 4 | 5,135 |
12-18-2017 05:34 PM Last Post: oldeskewltoy |
|
User(s) browsing this thread: 5 Guest(s)