4A-GE bellhousing on a 20 spline T50

[jondee86]

(09-29-2016 03:57 PM)The Doctor Wrote:  Who has done this and has some actual information about it?

Never did it and don't know nothing about it... BUT, I think that this is
the spacer you require (pic of GTS vs SR5 tranny)...



Apparently the earlier versions of the T-50 had a smaller (thinner ?) input
shaft bearing, and the spacer was to make up the difference. Otherwise
AFAIK the guts was exactly the same. Speedo gear was different due to
different diff ratio.

Note that I'm only guessing that the early AE85 tranny and the SR5 tranny
had the same input bearing. Could be wrong about all of this, but hey...
you have to start somewhere

Cheers... jondee86