Aram's 3SGE Beams Levin Coupe

[corolla4agze]

the oilpan is quite LOW? is there any room to go up or need totan new steel part to get it little higher?

[Aram]

Thanks Dave!

Yes the oilpan is very low, 7cm.
First on the list is making some protection for it. :-)

[ray]

nice work

[corolla4agze]

Aram Wrote:Thanks Dave!

Yes the oilpan is very low, 7cm.
First on the list is making some protection for it. :-)

I must look what i can do whit my self.. best would be make the lower steel-pan my self. WHIT 3-4cm lower but lot wider.. But i must look up to it.. WAY to low be without protection

[oldskull]

[oldskull]

[Aram]

corolla4agze Wrote:

Aram Wrote:Thanks Dave!

Yes the oilpan is very low, 7cm.
First on the list is making some protection for it. :-)

I must look what i can do whit my self.. best would be make the lower steel-pan my self. WHIT 3-4cm lower but lot wider.. But i must look up to it.. WAY to low be without protection

I like what Fer Monti has done: https://www.facebook.com/media/set/?set=...514&type=3
That will probably be a good solution.

[corolla4agze]

yep. i have looked same pictures. Lot better to get few cm from stock. Even that much it must help lot. Its sit so low whitout

[daveskatesallday]

Aram Wrote:Thanks Dave!

Yes the oilpan is very low, 7cm.
First on the list is making some protection for it. :-)

very welcome !

with the oil pan i'd assume you should be able to get bigger motor mounts or make some to raise it a bit to help or no?

[corolla4agze]

i think there is not much room whit Stock hood and beams "valve cover"