Q about rims-8'' users plz help
|
01-30-2009, 07:27 PM
Post: #11
|
|||
|
|||
Q about rims-8'' users plz help
14x8 ET0 with standard track width no mod required ... but with NRCA's u will need rolling....
|
|||
01-30-2009, 08:13 PM
Post: #12
|
|||
|
|||
Q about rims-8'' users plz help
15x7,5j -8 with 195/50/15 tyres. when the car lowered about 5cm it will touch the arch but not really bad as my rear suspension were a bit hard.
1985 AE86 (ハチロク) Levin - Summer time daily driver |
|||
01-30-2009, 11:35 PM
Post: #13
|
|||
|
|||
Q about rims-8'' users plz help
nmwisima Wrote:Back from the dead. I run Rota RB 15x8 et04 with 205/50-15 R888 tires on mine, however not sure if my results is very comparable as I have Kevlar front fenders/wings (though copy of stock I think) so take it for what it is worth. Car is lowered with TRD springs 8k/6k. In front the wheel is wider than fender unless I put more camber by the camberplates. At the rear I have 5mm spacers to fill the wheelhouse, and needed to adjust the wheel arch after that. Dont remember if it was fine or not without spacers but would guess so. PS! the 8x15 rota rb's also come with et +12. Possibly +12 front and +4 rear would be a good and safe setup? '85 AE86 4AGE, '94 SW20 3SGTE, '83 KP61, 72' RA21 |
|||
01-31-2009, 12:36 PM
Post: #14
|
|||
|
|||
Q about rims-8'' users plz help
Possibly...
danielvanderwoude Wrote:looks like the nmwisima joke saved you in the endhttp://www.jdmbits.com |
|||
« Next Oldest | Next Newest »
|
Possibly Related Threads... | |||||
Thread | Author | Replies | Views | Last Post | |
VEMS V3 Users feedback... | jondee86 | 12 | 15,685 |
09-08-2018 03:56 PM Last Post: conal g |
|
S2000 Cluster in 86 Corolla ?? pro's plz | geoscranny84 | 47 | 73,303 |
11-14-2016 11:16 AM Last Post: bozu |
|
Freedom ecu users forum | totta Crolla | 0 | 3,890 |
01-20-2016 12:29 PM Last Post: totta Crolla |
|
7" rims or 8" rims? | Lauren | 7 | 8,503 |
05-13-2012 06:04 PM Last Post: Lauren |
|
Left or right strut ??? PLZ HELP QUICK | KristianAE86 | 5 | 4,920 |
05-01-2005 10:57 AM Last Post: rikard |
User(s) browsing this thread: 1 Guest(s)