Smokey 20V

[allencr]

(12-01-2015 02:42 PM)pack Wrote:  I see smoke..... the oil level went from high to almost dry in 400kms...

Please don't bother with the seals.
No stem seals at all + the worst valve guide clearance in the world would not = a liter, let alone 2, in 400kms!!!!!

[d3nso]

Yes no bad valve seal gives you 1l+ consumption alone sounds hard but your rings are smoked. Had the same Problem on a friends honda engine he also thought it where the seals I told them it's the rings and I was right in the end

[pack]

Yeah it is piston rings.... My rear bumper is filled with grease from the oil......

[mad.matt]

(12-09-2015 12:09 PM)pack Wrote:  Yeah it is piston rings.... My rear bumper is filled with grease from the oil......

"Now, me and the mad scientist got to rip apart the block... and replace the piston rings you fried."

Sorry....too soon?

[pack]

(12-11-2015 03:56 PM)mad.matt Wrote:  

(12-09-2015 12:09 PM)pack Wrote:  Yeah it is piston rings.... My rear bumper is filled with grease from the oil......

"Now, me and the mad scientist got to rip apart the block... and replace the piston rings you fried."

Sorry....too soon?

I'm not sure if i understood your post... LOL

But yeah basically i will rebuild my engine now....

I'm aiming at

TRD - engine bearings
ARP bolts all around
Supertech valve seals
OEM piston rings

And.... basically this is it...

[Bean]

Make sure you get the right valve seals from Supertech as they do 2 sizes. One for the OEM valve guides and slightly slimmer ones for their own guides to suit the dual spring setup they offer.

[pack]

I noticed that when i was reading about the supertech seals.....

gon maybe has the references i need for the seals...

[isac]

I think 5mm is for 20v and 6mm to 16v. Not sure.

ACL bearings plenty sizes to choose. Proven to be good to.

   

[gon]

https://www.supertechperformance.com/s67...02&em=5593

I bought mine in uk through these guys .... [email protected]

[pack]

thanks