|
ring and pinion
|
|
11-10-2008, 07:24 PM
Post: #8
|
|||
|
|||
|
An update on this, I think it is sorted but if anyone could confirm that would be great. Basically the ring and pinion are installed, pre-loads done, backlash etc and a passable pattern marked on the teeth.
Is it normal for the ring and pinion to make a slight knocking noise consistent with speed when turned backwards ? An analogue brain in a digital World |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
ring and pinion - totta Crolla - 11-09-2008, 09:38 PM
[] - whitepoint - 11-09-2008, 10:08 PM
[] - totta Crolla - 11-09-2008, 10:54 PM
[] - whitepoint - 11-10-2008, 12:28 AM
[] - totta Crolla - 11-10-2008, 01:37 AM
Re: ring and pinion - assassin10000 - 11-10-2008, 05:53 AM
[] - totta Crolla - 11-10-2008 07:24 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| ring gear bolts | DJexor | 3 | 5,253 |
12-26-2016 10:56 PM Last Post: totta Crolla |
|
| DIY: a quick outline on why & how to set pinion angle. | assassin10000 | 9 | 17,763 |
12-21-2016 10:28 PM Last Post: ditn |
|
| Checking ring gear diff | izanagi | 3 | 4,868 |
07-09-2014 07:38 AM Last Post: jondee86 |
|
| Ring & pinion ratio. | izanagi | 27 | 26,270 |
07-05-2014 07:35 PM Last Post: assassin10000 |
|
| axle swap time how capable is a std crownwheel and pinion | fax0815 | 32 | 45,128 |
09-26-2013 08:33 PM Last Post: Lajoosh |
|
User(s) browsing this thread: 6 Guest(s)