Engine Rebuild

[williep12]

Hi all

To start off the new year its time for my engine rebuild.
Going to go with 20v ITBs and T3 adaptor with 75mm trumpets.
HKS cams
Polished and ported head.
Nonstop tuning adjustable pulley's.
Clear timing belt cover
HKS timing belt.
Nonstop Tuning water/alternator & crank pulleys
Silicon piping
Polished 4 into 1 exhaust header.
Aftermarket ECU.
And a few other bits.And then a trip down to Tom Casey to get her set up.
I took some of the photos with my phone so they aren't great, I took off the standard back bumper and replaced it with a new one to finish of the kit:nod:



















http://www.aeu86.org/viewtopic/shell-mak...int/t/9836


I will put up more photos as i go

[yaun]

keep it up man love the whole set up

[Project D]

What kind of ECU you plan to use for your setup ?

PS: I think I still have a fuel reg in stock but I have to check.

[Bean]

Nice project and car like it a lot I still have some 20V ITBs around but haven't sourced a manifold yet. Could you maybe take some clise up pictures of the T3 one inside where the transition between the round and rounded rectangular shape is?

Kind regards Bean

[williep12]

Hi Bean

This build is now finished you can view it below.

[slowboy2]

from what brand are your side skirts? and front spoiler?
very nice build.

[makkuro]

man, your engine sound sweet!

I love your glass cover.

[williep12]

[quote="slowboy2"]from what brand are your side skirts? and front spoiler?
very nice build. [/quote

Hi it's a CBY kit

[williep12]

makkuro Wrote:man, your engine sound sweet!

I love your glass cover.

ye she sounds good :wink: all 173 BHP

[Bean]

Do you have a dyno print (especially torque) and some more detailed specs of the power related mods?
I'm interested as I'm aiming for a similar figure in the longrun and missing just a few parts to finish it. Some details regarding the headwork would be nice too.