Aram's 3SGE Beams Levin Coupe

[Bean]

the round thingy on the last pic? is it a fuel pressure regulator?

[Aram]

the thing that "thing" is holding?
Yup.

[Bean]

yes indeed - what make is it, as it looks different than the aeromotive units I've known so far - link would do

[Aram]

oh, not sure mate, let me try and find out.

[Aram]

Btw, I tried to see how much of the bonnet I had to cut out, because all of the conversions I have seen sofar needed cutting to clear the camcover.
Strangly I have 10mm space left when I close the bonnet....

[Bean]

Aram Wrote:Btw, I tried to see how much of the bonnet I had to cut out, because all of the conversions I have seen sofar needed cutting to clear the camcover.
Strangly I have 10mm space left when I close the bonnet....

well done on the mounts then I guess just make sure the engine doesn't shake too much on start up

[Aram]

I think I'll hammer down the innerframe a bit, just to be sure.

[Aram]

Fuel pressure regulator is from Webcon I think.





Oh, and look what I drove through yesterday.

[Aram]

Finished the fuel and brake lines in the cabin:

Bulkhead:



Rear:



Bulkhead:





Wheelarch:



Rear:

[robokill]

very nice