Mintex pads

[Denmark]

Hi All.

I have a problem with the Mintex pads,they tend to fell out of the caliper mounting bracket,resulting in a long travel on the pedal.
it´s like the the place were the pads is held in,is to short!

I have now just gotten the rear pads,and i can see that they are made the same way,
they taps that are on the pads bend back.

Do any of you know what i´m writing?,
And if,do you have a solution to the problem?


Regards,
Skassa

[Ivan141]

Are you using all the mounting clips?
I usually stuggle to get brakepads in with those stupid little clips, so they might help to keep the pads in position.

[Denmark]

Yep,
I even got some new ones,but it´s on OE pads the pad is all flat ,if it´s put on a table with the backside down(it will be flat on the table)

If i do the same with the Mintex pad,the ends, are on the table,nut not the hole pad lying flat on the table.


Hmm,
I guess that none of you have the same problem

[Knudsen]

Last time i changed the rearpads (not mintex) they had the same bend to... I guess they have that bend, because the pads is a bit thinner than the OE ones. I bought new mounting clips for my Mintex, and havent got any problems so far

[Denmark]

Hmm,

It´s just that the clips will tilt,when that pads are outside the Caliper mounting bracket,

Last time when i took off the 1144 and put on the 1155mthe pads were realy messed up ,becourse they had only been pushed against the disc in the top of the pad


Thanks,