Big brakes on my SE-86 at last.

[Billzilla]

Long time no visit guys!

I'm being cheeky and have decided to call it an SE-86 from now on.

The big brakes are on, and they seem to work well so far.



The difference between the standard AE-86 disc and the big one.




Test fit on the strut.




16" wheel, still plenty of room left.




No backing plate, so I have to keep some temps in the brakes in puddles.



Here's the mounting bracket, milled from a large chunk of alloy.

Toyota RAV4 discs, 300m diameter 19mm thick & ventilated, Wilwood Dynalite four-spot cailpers, milled backing plate from a large chunk of alloy.
So far well worth the effort.

[Ivan141]

Looks good Bill..nice to see you around again.
Did you have to redrill the RAV discs or do they have the same PCD on the disc itself?

[jamiemirror]

AFAIK all RAVs use 5-holes pattern.

[Ivan141]

That's only on the hub, I believe the disc itself has a smaller PCD, as you can see in the pic of the two discs.

[jamiemirror]

Ivan141 Wrote:That's only on the hub, I believe the disc itself has a smaller PCD, as you can see in the pic of the two discs.

But RAV uses front wheel drive also - so PCD is something like 5X114mm vs 4X85mm in RWD AE86.

[Ivan141]

Forgot about that...so it's most likely redrilled.

[Mux213]

Hey long time no see bill, hope live has been treating you good. It sure has from the loops of it, atleast hachi wise

Damn those brakes look good!

[Billzilla]

Yep, they're re-drilled.
I tried to get them undrilled but couldn't do it.

Now to make the rears larger ....

[jamiemirror]

Billzilla Wrote:Now to make the rears larger ....

Nissan Primera (G20, P10, P11) rear discs are almost straight fit.
257mm

[Billzilla]

jamiemirror Wrote:

Billzilla Wrote:Now to make the rears larger ....

Nissan Primera (G20, P10, P11) rear discs are almost straight fit.
257mm

Thanks, but that's not a lot bigger than standard is it?
I was looking for something more like 300mm odd.