Swapping...
02-07-2008, 07:07 PM
Post: #21
Swapping...
Good choice, the GEO's came with the high compression 4age if i'm not mistaken...
BTW Apolan, miata's do have a nice transmission, but the engine's are real fuel guzzlers, and less interesting than 4age's imho.

FABRICA MI DIEM, PVNC!
Visit this user's website Find all posts by this user
02-07-2008, 07:32 PM
Post: #22
Swapping...
I love the RX7 trans but it's much heavier than the T50.

The Geo has the Red & Black Top. I would like to go with very high compression- any suggestion?

Thanks,
Vin
Find all posts by this user
02-07-2008, 08:41 PM
Post: #23
Swapping...
wiseco pistons or some other aftermarket brand will do the trick...or if you want to stay cheap, shave the head and use a thinner headgasket.

FABRICA MI DIEM, PVNC!
Visit this user's website Find all posts by this user
02-07-2008, 08:50 PM
Post: #24
Swapping...
I used to do a wacky trick- lapping the head to the block and not using a head gasket Smile It only works if the head gasket isn't used to block passages.
What do you think?
Find all posts by this user
02-07-2008, 08:54 PM
Post: #25
Swapping...
What the thinnest head gasket I can get and can I use pistons from a small port to increase my compression?
Thanks,
Vin
Find all posts by this user
02-08-2008, 12:58 AM
Post: #26
Swapping...
The intake manifold doesn't say T-VIS, so I confused...
Find all posts by this user
02-08-2008, 01:49 AM
Post: #27
Swapping...
Only the early bluetops had TVIS intakes. It just confirms that you have either a red, silver or blacktop 4AGE.

Nice going on the mpg front. Anyone can spin an engine to a gazillion rpm and make horsepower. It takes creativity and knowledge to make it fue efficient as well. Good luck!

A wheel to steer the front of the car
A pedal to steer the rear
Find all posts by this user
02-08-2008, 03:25 AM
Post: #28
Swapping...
Thanks for the encouragement!

I just took some pics, it seems that I have a Red & Black top small port. It's everything I wanted except for MAP.

btw NoHachi, I may use water injection without forced induction Smile

I'm going to start extracting the engine- is there a tutorial on what can be trashed from the fuel/emissions system?
Find all posts by this user
02-08-2008, 04:39 PM
Post: #29
Swapping...
Red & Black Top; red lettering on one half and black on the other.
It looks like this: http://www.freewebs.com/shatonapples...om%20above.JPG
Find all posts by this user
02-08-2008, 07:20 PM
Post: #30
Swapping...
vin Wrote:Bored... you may be right...

I just got rid of my TDi Sad
I had put in a European computer in it, had the computer reprogrammed, put in a smaller turbo, bumped the compression, and had a pipe from the turbo back. I was getting 65 mpg on the highway, at 70 mph. I also drove the thing into the ground. So now I want to do a gas high MPG. I've been doing high MPG cars since gas was $.85, so I don't think I'm going to stop now

I just bought a donor car last night. A Geo Prizm GSi with a nice 4AGE.

If only fuel was that cheap! Paying about $2.20 per litre right now. Sad Averaging 20mpg round town.
Find all posts by this user


Possibly Related Threads...
Thread Author Replies Views Last Post
  Swapping headlamp lenses Sanity Clause 10 9,234 01-17-2008 09:59 PM
Last Post: Jezza_hr

Forum Jump:


User(s) browsing this thread: 19 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication